OneUp Composite Bearing Rebuild Kit

• 1. remove outer and inner end caps with 6mm hex key. 
• 2. remove axle nut using 9mm socket. Drive side pedal (RH pedal) has left hand (reverse) threaded nut. Non Drive side pedal (LH pedal) has regular right hand threaded nut.
• 3. pull axle out of pedal body
• 4. push inner bearing out with 6mm hex 
• 5. to replace bushing use a flat head screw driver to pry against the inner surface of the bushing to pull it out. You will destroy the bushing by removing it.
• 6. remove axle seal (take note of direction)

REPLACEMENT INSTALL

• 1. grease new bushing and axle. Place bushing on axle and push it into pedal body.
• 2. replace pedal seal (thicker portion near flange of axle)
• 3. grease and place new bearing back into pedal body
• 4. slide axle through pedal body and bearing
• 5. replace axle nut
• 6. replace both end caps